Fiber Optic Systems : Fiber Optic Receivers & Transmitters : Evertz - 7708LTxx-B50

Wideband RF Fiber Transmitter, CWDM DFB laser 50ohm BNC Connectors, SmartMON

Model: 7708LTxx-B50

Extended frequency response for extended L-Band and off-air DTV signals
Protocol independent design - transports all modulation formats
LNB power with selectable 13/18V DC
LNB current limit & short circuit protection
LNB current monitoring for advance warning of LNB failure

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Related Products

Documents

The 7708LTxx-B50 is a fiber optic transmitter for RF signals in the extended L-Band or wider frequency range. It accepts a single RF input on coaxial cable and provides a single output for optical transmission. An RF monitor output provides a convenient means of obtaining peak satellite signal strength, or additional signal distribution.Gain may be adjusted manually or managed automatically via AGC. With SmartMON™, incoming RF signal strength, LNB current, and other data are relayed over the fiber output for monitoring through SNMP/VistaLINK® (requires SmartMON™ capable companion fiber receiver). 13/18V DC adjustable LNB power with 22kHz tone is also provided.

Extended frequency response for extended L-Band and off-air DTV signals
Protocol independent design - transports all modulation formats
LNB power with selectable 13/18V DC
LNB current limit & short circuit protection
LNB current monitoring for advance warning of LNB failure
22kHz tone on/off for LNB local oscillator control
RF monitor output for signal peaking and signal distribution
Manual gain and AGC modes
Wide range adjustable gain in 0.5dB steps for fine tuning signal levels and optimizing CNR
Available with 1310nm, CWDM (ITU-T G.694.2) and +11dBm high power DWDM (ITU-T G.694.1) laser options
The 7708LT occupies one card slot and can be housed in the 1RU 7801FR frame which holds up to four single or two dual slot modules, the 3RU 7800FR frame which has a 15 slot capacity, the portable 3RU 350FR frame which has a 7 slot capacity, or a standalone
SmartMON™ capability provides remote status monitoring via SNMP without a separate data connection
VistaLINK® capable for remote monitoring and control via SNMP (using VistaLINK® PRO) when installed in 7800FR frame with a 7700FC VistaLINK® Frame Controller
Fiber link provides electrical isolation between antenna and facility, mitigating ground loop and lightning issues

Fiber Optic Connector Type - Other
Fiber Optic Signals Supported - Other
Spec Sheet available - Yes

Maximum Frequency Response (Bandwidth): 3000000 kHz
Maximum Frequency Response (Bandwidth): 3000000000 Hz
Minimum Frequency Response (Bandwidth): 120000 kHz
Minimum Frequency Response (Bandwidth): 120000000 Hz
Active Power: 6 Watt
DC Voltage: 12 Volts
Regulatory Compliance: Class 1 laser product, 24CFR 1040.10 and 1040.11, IEC 60825-1, FCC Part 15, Class A, EU EMC Directive (EMI/RFI)
RF Input Number of Inputs: 1
RF Input Connector: BNC per IEC 61169-8 Annex A (F-Type and SMA optional)
RF Input Input impedance: 75 ohm (50ohm Optional)
Return Loss 120MHz to 2.3GHz: > 14 dB
Return Loss 2.3GHz to 3GHz: > 12 dB
Return Loss Input Power Range: -10dBm to -60dBm
Return Loss Gain Range: 0dB to +30dBm in 0.5dB steps
Return Loss IMD: < -55dBc at -15dBm input and 0dB gain
Return Loss Input IP3: +10dBm
LNB Power Voltage: 13V DC, 18V DC, off (selectable)
LNB Power Current: 400mA
LNB Power Protection: Short Circuit, current limited
LNB Power LO Control: 22kHz on/off (selectable)
RF Monitor Output Number of Outputs: 1
RF Monitor Output Connector: BNC per IEC 61169-8 Annex A (F-Type and SMA optional)
RF Monitor Output Output Impedance: 75 ohm (50ohm Optional)
RF Monitor Output Return Loss: > 15dB
RF Monitor Output Frequency Range: 120 to 3000 MHz
RF Monitor Output Output Level: within -1.5dB of input signal
Optical Output Number of Outputs: 1
Optical Output Connector: Female SC/UPC, ST/UPC, FC/UPC, SC/APC, FC/APC
Operating Wavelength Standard: 1310 Nm
Operating Wavelength CWDM: 1270-1610 Nm
Operating Wavelength DWDM: C-Band (ITU G.694.1 compliant)
Output Power Standard 1310nm: +2dBm
Output Power CWDM: +2dBm
Output Power DWDM: +11dBm
Frequency Range 950MHz to 2150MHz: ±1.5dB
Frequency Range 120MHz to 3GHz: ±2dB
Frequency Range 36MHz BW to 2.3GHz: ±0.25dB
Frequency Range 120MHz to 2.3GHz: ±2dB
Frequency Range 36MHz BW: ±0.25dB
Wavelengths CWDM: 1270,1290,1310,1330,1350,1370,1430,1450,1470,1490,1510,1530,1550,1570,1590,1610 Nm

7708LT - Wideband RF Fiber Transmitter with SmartMON

Wideband RF Fiber Transmitter with SmartMON 65 kb - Data Sheet

Project List